Filter
Top Products
Preparing the Audio Input System
46
Chapter 2 Preparations
8 Repeat steps 4 to 7 until the chart stays
in focus all the way from wide angle to
telephoto.
9 Tighten the F.f or F.B ring fixing
screws.
You can attach the ECM-680S stereo microphone
(not supplied) to the microphone holder of the
HDVF-20A viewfinder (not supplied).
1 Loosen the screw and open the
microphone holder clamp.
2 Place the microphone in the
microphone holder.
1 Wind the microphone spacer (sheet
type, supplied with the ECM-680S)
around the microphone, while peeling
off the protective sheets on both sides
of the microphone spacer.
2 Place the microphone in the holder so
that “UP” is at the top.
3 Close the microphone holder.
4 Tighten the screw.
Preparing the Audio
Input System
Connecting a microphone to the
MIC IN connector
1
2
Microphone holder clamp