Filter
Top Products
First use 11
2First use
2.1 Starting up the system
This paragraph guides you through the basic steps to start up the ECU-100 server and the
application and to bring the first inputs on the Display Wall:
Connect the components
Switch on the system
Launch Display Control
Display inputs on the wall
2.2 Connect the components
2.2.1 Getting started (cabling and connections)
Figure 1: USB input location
• Connect the USB Keyboard and Mouse into vacant USB connectors located on the rear
side of the unit.
Figure 2: Power connector location
• Connect both Power Cables to the chassis. Failure to connect both power cables will
result in an audible alarm being sounded when the system is switched on.
S2 USB Input connectors
P1 Power Connectors