Open as PDF
Installing and Removing the CF Card
Open the cover.
Turn the <4> switch to <2>.
Check that the “buSY” message is
not displayed on the LCD panel.
Make sure the access lamp is off,
then open the cover.
Remove the CF card.
Press the Eject button.
X The CF card will be ejected.
Close the cover.
Removing the CF Card
When the access lamp is lit or blinking, it indicates that the images
are being written to or read by the CF card or being erased. While
the access lamp is lit or blinking, do not do any of the following.
Doing so may damage the image data, CF card, or camera.
• Shaking or banging the camera around.
• Open the CF card slot cover.
• Removing the battery.
If “Err CF” (Error CF) is displayed on the LCD panel, see page 120.
If you use a low-capacity CF card, it might not be able to record large
A Microdrive is vulnerable to vibration and physical shock. If you use a
Microdrive, be careful not to subject the camera to vibration or physical
shock especially while recording or displaying images.
On the menu, if you set the [z Shoot w/o card] to [Off], it will prevent
shooting without a CF card. (p.99)