Canon 0296B002 Digital Camera User Manual

d Program AE
If “30"” and the maximum aperture blink, it indicates
underexposure. Increase the ISO speed or use flash.
If “8000” and the minimum aperture blink, it indicates
overexposure. Decrease the ISO speed or use an ND
filter (optional) to reduce the amount of light entering the
Differences Between <d> and <1> (Full Auto)
In both modes, the automatically-set shutter speed and aperture
combination are the same.
In the <d> mode, you can set or use the functions below, but not in the
<1> mode.
About Program Shift
In Program AE mode, you can freely change the shutter speed and
aperture value combination (program) set by the camera while
maintaining the same exposure value. This is called program shift.
To do this, press the shutter button down halfway, then turn the <6>
dial until the desired shutter speed or aperture value is displayed.
Program shift is canceled automatically after the image is captured.
If you use a flash, you cannot use program shift.
Shooting Settings
AF mode selection
AF point selection
Drive mode selection
ISO speed
Metering mode selection
Program Shift
Exposure compensation
AE lock with <A> button
Depth-of-field preview
Register camera settings
Clear registered camera set.
Clear all camera settings
Custom Function (C.Fn)
Clear all Custom Functions
Sensor cleaning
Flash Settings (EX-series Speedlite)
Manual/stroboscopic flash
High-speed sync (FP flash)
FE lock
Flash ratio control
Flash exposure compensation
2nd-curtain sync
Modeling flash
Image-Recording Settings
RAW and RAW+JPEG selection
Picture Style selection/customize/registration
White balance selection
Custom white balance selection
White balance correction
WB bracketing
Color temperature setting
Color space selection