Filter
Top Products
16 Chapter 1
Before Printing
(24)Duplexing Transport Unit
Open when clearing jammed paper after pulling out the Cassette.
(25)Power Connector
This is the connector used to connect the provided power cord.
(26)Rear Cover
Open when clearing jammed paper.
(27)USB Connector (for computer)
This is the connector used to connect the machine to a computer using a USB cable.
(28)Wired LAN Connection
Connects the machine to a computer with a wired LAN cable.
Operation Panel Name and Functions
(1) [ON/OFF]
Turns the machine ON and OFF. Before turning ON the machine, make sure the
Document Cover is closed.
(2) [COPY]
Switches the machine to Copy mode. Flashes when the machine is turned on.
(3) [SCAN]
Switches the machine to Scan mode. This button is used when the machine is connected
to a computer. (Refer to the Scan Guide.)
Important
While the machine is printing from or scanning images to the computer, or the computer is
in the sleep mode or standby mode, do not disconnect and connect the USB cable.
Note
z For information on how to install the Print Head and ink tanks, refer to the Setup Guide.
Ink Tank Lamps
z You can check the status of each ink tank according to the way its lamp flashes.
On: The machine is ready to print.
Slow flashing (about three seconds): Ink is low. Prepare a new ink tank. For details,
see “Getting the Ink Level Information” on page 108.
Fast flashing (about one second): Ink tank is empty, or the machine is not ready due to
an error.
Off: Make sure all the ink tanks are installed properly. If an Ink Tank Lamp remains unlit
even after reinstalling ink tanks, an error has occurred and the machine is not ready to
print.
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10) (11)(12) (13) (14) (15)
(16) (17)(18)(19)(20)(21)
(1)