Filter
Top Products
18 Chapter 1
Before Printing
Turning the Machine ON and OFF
Turn on the machine before starting printing.
Turning on the Machine
Before turning on the machine, confirm that the Print Head and ink tanks are set into place.
1 Press [ON/OFF].
[COPY] flashes green for a while, and then turns on.
Turning off the Machine
1 To turn off the machine, press [ON/OFF].
The machine is off when the currently selected Mode button (e.g. COPY) stops flashing and
all Operation Panel lamps are off.
Setting the Power Save Mode
The machine enters Power save mode if not operated for a certain interval. In the Power save
mode, the internal fluorescent lamp are turned off, and the selected Mode Lamp stays lit. You
can configure the interval that the machine waits before entering Power save mode. See “Power
save setting” on page 106.
When you try to copy or scan, the machine will exit from Power save mode.
If you use the machine frequently, we recommend that you set the Power save transfer time to 1
hour or 8 hours.
Note
If preparatory operations above are not yet finished, follow the Setup Guide to complete them.
Note
If the Alarm Lamp lights or flashes orange and an error message is displayed on the LCD, see
“An Error Message is Displayed on the LCD” on page 127.
Important
When removing the power plug after turning off the machine, be sure to check that all the
lamps on the Operation Panel are not lit. If the power plug is removed from the wall outlet with
the lamps on the Operation Panel lit or blinking, the machine cannot protect its Print Head and
may be unable to print.
See “Keeping the Best Printing Results” on page 113.