Filter
Top Products
133
Chapter 5 Settings
Action
Select the type of action to perform upon triggering from the pull-down list.
Select from [Report By Mail], [Start Beep], [Stop Beep], [Change Monitor
Layout], [Activate Alarm Out], [Deactivate Alarm Out], and [Recall
Preset].
The settings that appear subsequently vary depending on the action you
select here.
• When [Report By Mail] is selected
You can select whether to send a still image attachment in response to a
trigger. When there is an event such as a hardware failure or system error,
basic information about the error is included in the body text of the
message.
E-Mail (SMTP)
The recipient cannot be set here. Use “e-Mail” on the General screen
to enter a recipient address.
Caution
Configure the e-mail settings before configuring actions. If you
modify the e-mail settings after configuring an action, you need to
resave the corresponding action for the new settings to take effect.
Send Still Image
Select this check box to send a still image attached to the message.
However, when a still image cannot be generated, no still image is
attached to the message sent even if this check box is selected.
Camera
Select the camera to capture the still image.
• When [Start Beep] is selected
Duration (sec)
Specify the length of the beep in seconds.