Filter
Top Products
20
Chapter 2 Initial Configuring the System
When using a DHCP server to configure address settings
automatically
Select [DHCP].
When configuring addresses manually
(1) Select [Static].
(2) Enter the following information.
IP Address
Enter the desired IP address.
Caution
• Before you enter the desired IP address, make sure that it is not
already otherwise used on the network. Entering an IP address
already in use may lead to erratic operation of the unit, but no
error messages appear to indicate the fact.
• Because of IP address attribution rules, setting an invalid
address such as the ones below is not allowed.
Example: 224.0.0.0 to 255.255.255.255
0.0.0.0
127.0.0.1, etc.
Netmask
Enter the subnet mask address.
Note
The default settings for network devices are as follows.
IP Address: 192.168.[0/1/2]*.1
Netmask: 255.255.255.0
* The settings for each of the network devices #1, #2, and #3 (only
network device #1 for the NSR-25).
The [Monitor Model] screen appears.
9
Perform screen size settings depending on each monitor port, and then click
[Next].
When two monitors are connected, clicking [Dual Head] displays the
second monitor configuration screen.
Select the appropriate monitor type and resolution (pixels) for your monitor.
Notes
• The default setting for monitors is as follows.
Generic LCD Display; LCD Panel 1600
×1200; 31.5-90; 60
Resolution 1024
×768
• Most monitors will operate with [Generic Monitor], but you can select
[Others] as required.