Open as PDF
Internal Cover It is a cover to protect the main body.
Illumination Sensor Detects incoming light to control the IR LED.
Lens Lens for the camera.
IR LED These infrared LED’s are controlled by the illumination sensor.
T Zoom in (Tele)
W Zoom out (Wide)
N Focusing on a near object (Near)
F Focusing on a far object (Far)
Focus Control Press this button for automatic focus control.
The button restores all camera settings to the factory default.
Press and hold for about 5 seconds to reboot the system.
If you reset the camera, the network settings will be adjusted so that
DHCP can be enabled. If there is no DHCP server in the network, you
must run the IP Installer program to change the basic network settings
such as IP address, Subnet mask, Gateway, etc., before you can
connect to the network.
Test Monitor Out
Output port for test monitoring the video output. Use the test monitor cable
to connect to a mobile display and check the test video.
Alarm I/O Port
Used to connect the alarm input sensor or external day/
ALARM OUT Used to connect the alarm output signal.
GND Common port for alarm output signal.
Power Port Port for power terminal block.