Samsung SND-5084R Digital Camera User Manual


 
overview
20_ overview
Item Description
a
Illumination Sensor Detects incoming light to control the IR LED.
b
Lens Lens for the camera.
c
IR LED These infrared LED’s are controlled by the illumination sensor.
d
Power Port Port for power terminal block.
e
Test Monitor Out
Output port for test monitoring the video output. Use the test monitor cable
to connect to a mobile display and check the test video.
f
Reset Button
The button restores all camera settings to the factory default.
Press and hold for about 5 seconds to reboot the system.
J
If you reset the camera, the network settings will be adjusted so that
DHCP can be enabled. If there is no DHCP server in the network, you
must run the IP Installer program to change the basic network settings
such as IP address, Subnet mask, Gateway, etc., before you can
connect to the network.
g
Zoom/Focus Control
Button
T Zoom in (Tele)
W Zoom out (Wide)
N Focusing on a near object (Near)
F Focusing on a far object (Far)
Focus Control Press this button for automatic focus control.
h
Micro SD Memory
Card Compartment
Compartment for the Micro SD memory card.
i
Audio and alarm
cable port
Plug in the audio and alarm cable to this port to connect with external alarm
device/microphone/speaker.
j
Network Port Used to connect the PoE or Ethernet cable for network connection.