Filter
Top Products
TROUBLESHOOTING
Problem Cause Action
Reference
page
Power No power. The batteries are dead. Change or recharge the
batteries.
23, 26
The batteries have not
been inserted correctly.
Reinsert the batteries,
making sure the polarity
(+), (–) is as indicated.
The battery
compartment cover is
not fully closed.
Close battery
compartment cover
properly.
Due to cold
temperatures, the
batteries temporarily
lost their power.
Place the digital camera in
your pocket to warm it up
before using it.
48
Shooting An image is not
captured when the
shutter release
button is pressed.
The power is not
turned on.
If the power save function
has turned the digital
camera off, then press the
MODE button, or press
once on the shutter
release button to turn the
digital camera back on.
30
The stand-by indicator
is flashing red (the
digital camera is
becoming ready to
capture an image).
Wait until the stand-by
indicator lights green to
capture the image. 22
Accessing indicator
lights red.
Recorded data is
being saved on the
card.
Not a malfunction.
Wait until the stand-by
indicator lights green to
capture the image.
—
An image is not
captured when the
shutter release
button is pressed.
The memory is full (the
stand-by indicator
lights red, the
displayed remaining
number of images that
can be captured
becomes [0] on the
LCD monitor).
Install a new card. 27, 28
Erase the images that are
not necessary. Save the
images to separate media,
then erase all the images
from the card.
52, 116
The flash does not
light.
The flash off mode is
selected.
Set the flash to automatic
flash mode or forced flash
mode.
73
The digital camera has
determined that the
image is bright enough
and the flash is not
necessary.
Not a malfunction. Capture
the image; the digital
camera will determine
when the flash is
necessary.
—
The batteries are dead. Change or recharge the
batteries.
23, 26
SX511/EX, /E, /U (VPC-AZ1EX, VPC-AZ1E, VPC-AZ1 GB) Thu. Nov., 29/2001
English
130