Filter
Top Products
CHECKING THE REMAINING NUMBER OF IMAGES,
VIDEO RECORDING TIME, AND AUDIO RECORDING TIME
The images, video clips, and audio recordings you take are stored on the card installed in the
digital camera. If a card is not loaded into the digital camera or if the card is full, capturing or
playing back images will not be possible. Make sure to check the status of the card in the digital
camera before capturing images. For an indication of how many images can be captured and how
much recording time is available for your card, see “Possible No. of Images/Possible Shooting
Time/Possible Recording Time” on page 136.
Checking the remaining number of images
and video recording time
1
Set the main switch to Õ, and press the power button.
œ Set the selector dial to anything other than P or Ü.
œ The remaining number of images appears in the upper
right of the LCD monitor (for the still image and
sequential shot shooting modes).
œ The remaining video recording time appears in the
upper right of the LCD monitor (for the video clip
shooting mode).
œ The remaining number of images and video recording
time will differ depending on the resolution and
compression settings.
œ When the remaining number of images or the remaining
time of video clips that can be taken is “0”, you cannot
capture any more images. To capture more images,
either install a new card, or save the current images
(see page 52) and then erase them (see page 116) from
the card.
œ When the remaining number of images or the remaining
time of video clips that can be taken is “0”, it may be
possible to capture a few more images by changing the
shooting mode, setting a lower resolution setting (see
page 55), or selecting a different compression setting
(see page 57).
MONITOR OFF
Main switch
Selector dial
Power
button
13
3.1
1/50
Remaining number of images possible
(Still Image Shooting Screen)
13
3.1
1/50
Remaining number of images possible
(Sequential Shot Shooting Screen)
00:24
Remaining video recording time (min:sec)
(Video Clip Shooting Screen)
Depending on the memory capacity
of the card, the remaining time is
shown as “hr:min:sec”.
SX511/EX, /E, /U (VPC-AZ1EX, VPC-AZ1E, VPC-AZ1 GB) Thu. Nov., 29/2001
English
50