Filter
Top Products
Problem Cause Action
Reference
page
Audio
recordings
No sound. The volume setting on
the digital camera is
too low.
Select the volume icon
N and adjust the volume. 98
No voice memo was
recorded with the
image.
Add a voice memo as
desired. 109
When using the
Microdrive, excess
noise was also
recorded.
The drive noise for the
Microdrive was also
recorded.
Not a malfunction.
—
A mechanical sound
is heard during
video clip playback.
The sound of the
autofocus motor was
recorded.
Not a malfunction.
Connecting
to television
set
No image or sound. The digital camera is
not correctly
connected to the TV.
Follow the instructions to
make the connection
correctly.
106
The TV input is not set
correctly.
Set the input on the TV to
“VIDEO”.
The TV system setting
is not correct.
Set to the correct TV
system.
128
There is no sound. The volume on the TV
is set to the minimum.
Adjust the volume on the
TV.
106
The volume setting on
the digital camera is
too low.
Select the volume icon
N and adjust the volume.
Miscellaneous A sound is heard
when the main
switch is moved or
the digital camera
is turned on.
Normal condition. Not a malfunction.
—
The digital camera
cannot be operated.
A temporary internal
circuitry problem may
be the cause.
Remove the batteries from
the digital camera, wait a
few minutes then reinstall
the batteries and try again.
“SYSTEM ERROR”
is displayed.
A problem has
occurred within the
digital camera or card.
Check the following items
1 Remove the card and
then install it again.
2 Remove the batteries
and then install them
again.
3 Remove the batteries,
wait approx. 1 hour,
and then install them
again.
4 Install a different card.
If “SYSTEM ERROR” still
appears after performing
the above steps, then take
the digital camera to the
dealer for service.
TROUBLESHOOTING
SX511/EX, /E, /U (VPC-AZ1EX, VPC-AZ1E, VPC-AZ1 GB) Thu. Nov., 29/2001
133
English