Open as PDF
Chapter 1 Overview
20 Chapter 1 Overview
Location and Function of Parts
Indications in the display window (continued)
This indicates the battery capacity and voltage as shown below.
Change menu setting for the battery you are using.
For menu settings, see “Selecting Battery Capacity Indication
Menu 206” (page 120).
BATT E[xxxxxx]F 15.0 V or more 12.5 V or more 14.0 V or more
BATT E[xxxxx ]F 14.0 to 15.0 V 12.0 to 12.5 V 13.65 V to 14.0 V
BATT E[xxxxp]F 13.0 to 14.0 V 11.75 to 12.0 V 13.40 V to 13.65 V
BATT E[xxx p]F 12.0 to 13.0 V 11.5 to 11.75 V 12.90 V to 13.40 V
BATT E[xxpp]F 11.3 to 12.0 V 11.3 to 11.5 V 12.40 V to 12.90 V
BATT E[xxpp]F (blinking)
11.25 to 11.3 V 11.25 to 11.3 V 12.25 V to 12.40 V
BATT E[x pp]F (blinking) 11.0 to 11.25 V 11.0 to 11.25 V 11.00 V to 12.25 V
BATT E[ppp]F (blinking) 11.0 V or less 11.0 V or less 11.0 V or less
1) Replace the battery pack when this indication appears.
J Lithium backup
Appears when the voltage of the internal lithium backup battery (CR2032) is low. If this
indication appears, replace the lithium backup battery immediately.
For further information about replacing lithium battery, see “Inserting and Replacing
the Lithium Battery” (page 37).
Disappears when the cassette being played back is not for DVCAM format.
Appears when using a cassette with cassette memory.
M Audio mode
These show audio recording/playback mode.
Fs32k: 4-channel mode (32kHz sampling frequency)
Fs48k: 2-channel mode (48kHz sampling frequency)
For further information about selecting audio recording mode, see “Selecting Audio
Menu 212” (page 123).
Include the following.
RF: Appears when the video heads are clogged, or when there is a fault in the
SERVO: Appears when the servo lock is not functioning.
HUMID: Appears when there is condensation on the drum.
SLACK: Appears when there is a tape winding fault.
For measures against warning indications, see “Warning System” (page 142).
Appears during maintenance or VCR menu operations
. It does not appear
during normal operation.