Sony 370PL Camera Accessories User Manual


 
40 Chapter 2 Fitting and Connections
Chapter 2 Fitting and Connections
If using a
1
/2 lens other than the VCL-716BX/
719BX on DSR-370/370P
If the connector on the lens attachment section is a 14-
pin connector (VCL-714BXA and other lenses), then
the lens may be operated in the same way as the VCL-
716BX/719BX.
If the lens has a 7-pin connector, then the following
limitations apply.
The lens iris f. value is not displayed in the
viewfinder.
Iris operation may be slow in auto iris mode, and
hunting may occur. If this happens, you should adjust
the iris sensitivity (see page 135).
If using a lens with a 6-pin connector
This camcorder head has a 12-pin LENS connector. If
the lens cable has a 6-pin connector, fit an adaptor
cable: LO-612 (manufactured by Canon) or ECF-124
(manufactured by Fujinon) or equivalent.
When using a lens with a 6-pin connector, the
following limitations apply.
The lens iris f. value is not displayed in the
viewfinder.
Iris operation may be slow in auto iris mode, and
hunting may occur. If this happens, you should adjust
the iris sensitivity (see page 135).
If using a
2
/3 lens (for only DSR-370/370P)
Fit the lens using the optional LO-32BMT
2
/3 lens
adaptor.
Fitting optional filters
Loosen the lens hood fixing screw to remove the lens
hood, then attach the filter.
Use a commercially available M82 × 0.75 size screw
to attach the filter.
Remove lens hood
Lens hood fixing
screw
Filter (optional)
Fitting the Lens