Filter
Top Products
4-54
DVW-790WS/709WS/707
DVW-790WSP/709WSP/707P P2V1
4-2. Parts Replacement
Removal
1. Mechanical Deck Assembly Removal
(1) Remove the four screws shown in the figure
using the hexagon bit.
n
These screws can not be removed due to the
drop-safe.
(2) Lift up the ornamental bracket of the HN-260
board and disconnect the 100-pin connector
that connects to the mother board at the bottom
of the HN-260 board.
(3) While holding the shaded portion of the arm
on the cassette compartment, or cassette guide,
and HN-260 board shown in the figure, lift up
and remove the mechanical deck assembly
from the unit.
m
. When removing, take care not to scratch the vid-
eo heads, drum and other parts.
. Never put the removed mechanical deck assem-
bly to bottom side down or up side down on the
desk.
. In the replacement, put the mechanical deck as-
sembly as shown in the figure and carry out the
following steps while holding it by hand.
HN-260 board
100-pin connector
Cassette guide
Cassette
compartment
arm
Screws
(with drop-safe)
Mechanical deck assembly
Scrwes
(with drop-safe)