Filter
Top Products
7-24
DVW-790WS/709WS/707
DVW-790WSP/709WSP/707P P2V1
7-16-3. Detail Frequency Adjustment (16:9)
16:9 mode
Note
Perform this adjustment, if necessary, to suit the custom-
er’s preferences.
Preparation
. On the setup menu, set as follows.
PAGE : S12*FUNCTION 1/2
ITEM : DETAIL → ON
ITEM : TEST OUT → ENC
. OUTPUT/DCC switch (inside panel) → CAM/ON
. Shoot a grayscale chart (16:9) in the full underscanned
monitor frame.
Equipment : Waveform monitor
Test point : TEST OUT connector
Setting point : 1 Lens IRIS
Spec. : A = 100 ± 2 IRE (NTSC)
A = 700 ±14 mV (PAL)
. Select the line at the center white portion of the gray-
scale chart.
Adjustment Procedure
Equipment : Waveform monitor
Test point : TEST OUT connector
1. Select the 16:9 mode.
PAGE : S14*WIDE SCREEN
ITEM : 16:9/4:3 MODE → 16:9
2. On the setup menu, adjust as follows.
PAGE : S16*LEVEL 1
ITEM : DTL FREQ. (Factory setting: 0)
Spec. : Set the desired width at the edge of
portion B.
Note
After this adjustment, be sure to perform Section 7-16-4
“H/V Ratio Adjustment (16:9)”, and Section 7-16-5
“Detail Level Adjustment (16:9)”, in that order.
7-16-4. H/V Ratio Adjustment (16:9)
16:9 mode
Preparation
. On the setup menu, set as follows.
PAGE : S12*FUNCTION 1/2
ITEM : DETAIL → ON
ITEM : TEST OUT → ENC
. OUTPUT/DCC switch (inside panel) → CAM/ON
. Shoot a grayscale chart (16:9) in the full underscanned
monitor frame.
Equipment : Waveform monitor
Test point : TEST OUT connector
Setting point : 1 Lens IRIS
Spec. : A = 100 ±2 IRE (NTSC)
A = 700 ±14 mV (PAL)
Adjustment Procedure
Equipment : Black and white monitor
Test point : TEST OUT connector
1. Select the 16:9 mode.
PAGE : S14*WIDE SCREEN
ITEM : 16:9/4:3 MODE → 16:9
2. On the setup menu, adjust as follows.
PAGE : S16*LEVEL 1
ITEM : H/V RATIO
Spec. : Adjust so that the H and V detail
amounts which are added are equiva-
lent.
A
B
A
H
V
7-16. Detail Signal Adjustment (16:9)