Filter
Top Products
8-19
DVW-790WS/709WS/707
DVW-790WSP/709WSP/707P P2V1
8-16-2. Level Depandent Adjustment
Preparation
. On the setup menu, set as follows.
PAGE : S12*FUNCTION 1/2
ITEM : DETAIL → ON
ITEM : TEST OUT → ENC
PAGE : S16*LEVEL 1
ITEM : LVL DEPEND → ON
. OUTPUT/DCC switch (inside panel) → CAM/ON
. Shoot a grayscale chart in the full underscanned monitor
frame.
Equipment : Waveform monitor
Test point : TEST OUT connector
Setting point : 1Lens IRIS
Spec. : A = 100 ±2 IRE (NTSC)
A = 700 ±14 mV (PAL)
Adjustment Procedure
Equipment : Waveform monitor
Test point : TEST OUT connector
1. On the setup menu, adjust as follows.
PAGE : S16*LEVEL 1
ITEM : L.DEP.LVL
Spec. : Eliminate the detail signal from portion B.
Note
After this adjustment, be sure to perform Section 8-16-4
“H/V Ratio Adjustment”, and Section 8-16-5 “Detail Level
Adjustment”, in that order.
8-16. Detail Signal Adjustment
A
8-16. Detail Signal Adjustment
8-16-1. Crispening Adjustment
Preparation
. On the setup menu, set as follows.
PAGE : S12*FUNCTION 1/2
ITEM : DETAIL → ON
. OUTPUT/DCC switch (inside panel) → CAM/ON
. Shoot a grayscale chart in the full underscanned monitor
frame.
Equipment : Waveform monitor
Test point : TEST OUT connector
Setting point : 1Lens IRIS
Spec. : A = 100 ±2 IRE (NTSC)
A = 700 ±14 mV (PAL)
Adjustment Procedure
Equipment : Black and white monitor
Test point : TEST OUT connector
1. On the setup menu, adjust as follows.
PAGE :S16*LEVEL 1
ITEM :CRISPENING
Spec. : Reduce the noise at gray portion to a
permissible level.
A
B