Filter
Top Products
4-82
DVW-790WS/709WS/707 P2V1
DVW-790WSP/709WSP/707P P2V1
4-2. Parts Replacement
Installation
2. Detection Pins Installation
Attach the detection pins to the sensor cover (A) in
the direction of the arrow shown in the figure.
n
When attaching the sensor cover (A), to prevent
from the falling, it recommends that the adhesive
tape is put on the position shown in the figure. Af-
ter carrying out step 3, peel off and check that the
adhesive tape is not put on the outer circumference
of the detection pins.
3. Sensor Cover (A) Installation
Put the one boss and the three hooks of the sensor
cover (A) in the four holes on the SE-210 board in
the sequence of the figure and attach them.
4. Operation Check
Check that the detection pins move freely in the
direction of the vertical and return it back into the
position.
Detection pins
Detection
pins
Sensor cover (A)
Adhesive tape
Sensor cover (A)
Adhesive tape
3 (claw)
1 (claw)
2 (claw)
Boss