Filter
Top Products
3-27
DVW-790WS/709WS/707
DVW-790WSP/709WSP/707P P2V1
3-6. Replacing the Camera SW Ornamental Plate
Removal
Required tool
. Sealant TSE-392W : 7-432-950-03
1. Remove the remaining old sealant from the
surface of the inside panel (
portion in the
figure) using a flatbrade screwdriver.
2. Reattach the camera SW ornamental plate to
the inside panel using the two screws.
Standard tightening torque :
15 x 10
_2
N.m {1.5 kgf.cm}
3. Apply a sufficient amount of sealant from
through inside the inside panel until the hole
and the stud ( portion in the figure) are
covered by the sealant.
MENU
OFF
ON
OFF
POWER
VTR
ON
PAGE ITEM
CANCEL/PRST
GAIN
OUTPUT
WHITE BAL
ASSIGNABLE
0.4 mm or less
Inside panel
Camera SW ornamental plate
4. Check that the clearance between the camera
SW ornamental plate and the inside panel is
0.4 mm or less when checked from the
outside.
5. Reattach the CP-329 board and the inside
panel by reversing the removing steps.
TP 2x4
Hole of
the inside panle
Stud of the camera SW
ornamental plate
Sealant
Camera SW ornamenta
plate