Filter
Top Products
8-7
DVW-790WS/709WS/707
DVW-790WSP/709WSP/707P P2V1
10. On the setup menu, adjust as follows.
PAGE : S39*SG ADJ.
ITEM : H BLANKING WIDTH
Spec. : D = 10.9 ± 0.2 us (NTSC)
D = 12.0 ± 0.3 us (PAL)
11.
On the setup menu, adjust as follows. (For only NTSC)
PAGE : S39*SG ADJ.
ITEM : V BLANKING WIDTH
Spec. : 20H or 21H
8-4-3. INT SC Phase Adjustment
Note
The following adjustment procedures are described under
the condition by using the Tektronix 1750/1751. If any
other measuring instrument is used, perform the adjust-
ment according to the operation manual attached to it.
Preparation
. On the setup menu, set as follows.
PAGE : S24*ELEVEL 7
ITEM : TEST OUT → ENC
Adjustment Procedure
Equipment : Waveform/Vector monitor
(SC-H Phase measuring mode)
Test point : TEST OUT connector
1. On the setup menu, adjust as follows.
PAGE : S28*LEVEL 11
ITEM : SC PHASE
Spec. : Coincide the beam spot of the burst
(SC) with the direction of the beam
spot of H.
Setting After Adjustment
Connect the waveform monitor to the TEST OUT connec-
tor.
8-4. ENC OUT Adjustment
ES-23 board
(
A side
)
1
FL12
A
1
2
3
4
5
BC DEFG
R
M
G
C
Y
G
Y
L
B
R
M
G
CY
G
Y
L
B
(For NTSC) (For PAL)
20 IRE (NTSC)
140 mV (PAL)
D