Filter
Top Products
7-34
DVW-790WS/709WS/707
DVW-790WSP/709WSP/707P P2V1
7-21. Adjustment After Replacing the
Filter Disk Unit
After replacing the filter disk, the white balance adjustment
must be corrected. Follow the correction procedure
described below.
Preparation
. WHITE BAL switch (on the inside panel) → Position
A or B
. Shoot a fully occupied white area of pattern box in the
underscanned monitor frame.
. Lens IRIS → AUTO
Adjustment Procedure
Equipment : Color monitor
1. On the setup menu, set as follows.
PAGE : S55*ND COMP.
ITEM : ND DETECTION → EXEC
2. Set the filter knob to the “1B” position.
3. AUTO W/B BAL switch (front panel) → WHT
(Perform the automatic white balance adjustment.)
n
Check that the indication “ND1 DET. = OK!” appears
on the color monitor after the automatic white balance
adjustment is completed.
4. Set the filter knob to the “2B” to “4B” positions in
turn, and perform step 3 for each position.
n
When the adjustment is completed for all knob
positions “1B” to “4B”, the indication “COMPLETE!”
appears and the ITEM setup returns automatically to
the OFF position.
7-21. Adjustment After Replacing the Filter Disk Unit