Filter
Top Products
7-19
DVW-790WS/709WS/707
DVW-790WSP/709WSP/707P P2V1
7-14. Flare Adjustment
16:9 mode
Preparation
. On the setup menu, set as follows.
PAGE : S24*LEVEL 7
ITEM : TEST OUT → ENC
. OUTPUT/DCC switch (inside panel) → CAM/ON
. Shoot a grayscale chart (16:9) in the full underscanned
monitor frame.
Equipment : Waveform monitor
Test point : TEST OUT connector
Setting point : 1 Lens IRIS
Spec. : Open the lens iris by one step from the
reference setting
A = 100 ±2 IRE (NTSC)
A = 700 ±14 mV (PAL)
Adjustment Procedure
Equipment : Waveform monitor
Test point : TEST OUT connector
1. Select the 16:9 mode.
PAGE : S14*WIDE SCREEN
ITEM : 16:9/4:3 MODE → 16:9
2. On the setup menu, set as follows.
PAGE : S24*LEVEL 7
ITEM : G FLARE → 0
3. Select portion B by using the waveform monitor.
4. On the setup menu, adjust as follows.
PAGE : S24*LEVEL 7
ITEM : R FLARE
Spec. :
Minimize the carrier leakage at portion C
5. On the setup menu, adjust as follows.
PAGE : S24*LEVEL 7
ITEM : B FLARE
Spec. :
Minimize the carrier leakage at portion C.
6. Repeat steps 4 and 5 several times.
A
7-14. Flare Adjustment
B
C