Filter
Top Products
5-10
DVW-790WS/709WS/707
DVW-790WSP/709WSP/707P P2V1
Adjustments
9. T2 and T3 Guides Height Adjustment
(1) Enter the PLAY mode at the tape top of ZR2-1/P (from 5 minute to 10 minute segment).
(2) Loosen the set screws at the top of theguides using the tape guide adjustment screwdriver. Turn the
upper flanges of the guides, and adjust the heights of the guides so that satisfy the specifications 4 to
7.
Reference for adjustment
If case that the specification is not satisfied when REVx1 mode
. Turn the upper flange of the T3 guide when the REVx1 mode and adjust the height so that the tape
runs without any curl.
. After this adjustment, enter the PLAY mode and check that the clearance between upper and lower
flanges of the T3 guide and tape.
(3) Tighten the set screws at the top of the guides.
10. Tape Running Re-check at the Drum Exit Side
Perform the steps 1 to 8 of the check procedures, re-check that the specifications satisfy.
If the specifications are not satisfied, re-carry out the adjustment of the step 9.
11. Tape Running Re-check at the Drum Entrance Side
Re-check the tape running adjustment at the drum entrance side.
Checks and Adjustments After Adjustment
12. Video Tracking Check
Refer to section 5-2.
13. CUE Head Height Check
Refer to section 5-5.
14. CUE Head Azimuth Adjustment
Refer to section 5-6.
15. CUE Head Height Check
Refer to section 5-5.
16. CTL Head Position Check
Refer to section 5-4.
17. CUE/TC Head Position Check
Refer to section 5-8.
5-1. Tape Running Adjustment