Filter
Top Products
Menu List
149
Chapter 6 Menu Displays and Detailed Settings
06 AUDIO-1 FRONT MIC
SELECT
MONO/STREO Input mode selection for front microphone.
AUDIO CH3/4
MODE
CH1/2/SW Selects the sources to be recorded to channels CH-
3/4.
CH1/2: Same sources as CH-1/2.
SW: Signals selected by the AUDIO IN CH-3/CH-
4 switches.
REAR XLR
AUTO
OFF/ON Turns the XLR connection automatic detection on
or off.
FRONT MIC REF –60dB/–50dB/
–40dB
Sets the reference level of the front microphone.
REAR MIC REF –60dB/–50dB/
–40dB
Sets the reference level when the AUDIO IN CH1
connector is set to MIC.
MIN ALARM
VOL
OFF/SET Volume of the monitor speaker alarm tone when it
is turned all the way down.
OFF: Almost inaudible.
SET: Faintly audible.
SP ATT LEVEL OFF/3dB/6dB/
9dB
Lowers the volume of the monitor speaker. Has no
effect on earphone volume.
HEADPHONE
OUT
MONO/STREO Selects whether to make the rear earphone
monaural or stereo.
07 AUDIO-2 AU DATA LEN
(IMX)
(When the CBKZ-
MD01 is installed)
16bit/24bit For details, see “Setting the Recording Format”
(page 54).
AU REF LEVEL –20dB/–18dB/
–16dB/–12dB/
EBUL
Sets the output level of the 1 kHz test signal.
AU REF OUT 0dB/+4dB/
–3dB/EBUL
Sets the output reference level.
AU CH12 AGC
MODE
MONO/STREO Selects whether to perform automatic input level
adjustment of analog audio signals to be recorded
on channels 1 and 2 independently for each
channel, or in stereo mode.
AU CH34 AGC
MODE
MONO/STREO/
OFF
Selects whether to perform automatic input level
adjustment of analog audio signals to be recorded
on channels 3 and 4 independently for each
channel, or in stereo mode, or not at all (OFF).
AU AGC SPEC –6dB/–9dB/
–12dB/–15dB/
–17dB
AGC saturation level setting.
AU LIMITER
MODE
OFF/–6dB/
–9dB/–12dB/
–15dB/–17dB
For manual audio input level adjustment, selects
the limiter saturation level for loud input signals.
AU OUT
LIMITER
OFF/ON Turns the audio output limiter on or off.
No. Page Item Settings Description