Filter
Top Products
Operation Warnings
219
Chapter 9 Maintenance
a) Contact a Sony service representative to replace the
battery.
VDR operation messages are displayed in the
setting change and adjustment progress message
display area of the viewfinder screen (see
page 34). Take the actions listed in the following
table.
AUTO
INTERVAL
**M**S
The unit is operating in Auto
Interval Rec mode (**M**S:
Indicates the shooting interval in
minutes and seconds).
MANU
INTERVAL
*FRAME
The unit is operating in the single-
shot mode of Manual Interval Rec
mode (*FRAME: Indicates the
number of frames recorded in one
shot).
INTERVAL
**S (M/H)
*FRAME
The unit is operating in the
consecutive mode of Manual
Interval Rec mode (**S (M/H):
Indicates the trigger interval, in
seconds (minutes or hours),
*FRAME: Indicates the number
of frames recorded in one shot).
LOW LIGHT Depending on the setting, the
subject illumination is inadequate.
ON-BOARD
BATTERY
EMPTY
The backup battery of the internal
clock is empty.
a)
DCP
EEPROM
DATA NG!
DR EEPROM
DATA NG!
DCP/DR
EEPROM
DATA NG!
If this message continues to
appear even after the unit is
powered off and on again several
times, then the factory adjustment
data is invalid. Contact a Sony
service representative.
ILL. Disc! A disc that cannot be used by this
unit was inserted. Insert another
Professional Disc.
ILL. Index!
No FS!
Unknown FS!
Index file or file system error.
Exchange or format the disc.
No Support! A recorded clip cannot be handled
by this unit. Exchange or format
the disc.
FORMAT
NG!
The disc could not be formatted
automatically. Exchange the disc.
Disc Damage A disc that cannot be recorded was
inserted. To record, exchange the
disc.
Non AV Full
MAX # Files
Over DUR!
The disc is full. Exchange or
format the disc.
DI read err
Read err
DRV ADJ err
The disc was not recognized. Try
ejecting the disc and inserting it
again. Or exchange the disc.
Run Salvage A disc that requires salvage was
inserted. To record on the disc,
eject the disc, insert it again, and
execute salvage processing.
Salvage NG! Salvage processing failed.
For details, see “Handling of discs
when recording does not end
normally (salvage function)” on
page 74.
Salvage
XXXX
The loaded disc cannot be
salvaged by this unit. The
“XXXX” in the message is a code
for XDCAM devices that can
salvage the disc. Refer to the list
of device codes (see page 75) and
salvage the disc using one of the
indicated devices.
REC INHI.! The Write Inhibit tab of the disc is
in the recording disabled position,
or salvage processing needs to be
done on the loaded disc. Set the
tab to the recording enabled
position. Or eject the disc, insert it
again, and perform salvage
processing.
1080/50i
1080/25P
1080/59.94i
1080/29.97P
720/50P
720/59.94P
625/50i
525/59.94i
The loaded disc has a different
resolution or a different system
frequency. To carry out recording
operations, exchange the disc, or
change the resolution or system
frequency.