Sony PDW-700 Camcorder User Manual


 
File Operations in File Access Mode (for Macintosh)
201
Chapter 8 File Operations
To make a reconnection
To reconnect after exiting file operations, do one
of the following, depending on whether an
i.LINK cable is connected.
i.LINK cable is not connected: Connect this unit
and a remote computer with an i.LINK cable.
i.LINK cable is connected: Disconnect the
i.LINK cable from either this unit or the
remote computer, wait for at least 10
seconds, and then reconnect the disconnected
cable.
The unit is powered off and an i.LINK cable is
connected: Power the unit on.
File access mode operating environment
Operating system requirements for file operations
by file access mode are as follows.
Computer operating system: Mac OS X
v10.4.11 or higher
Preparations
Do the following on the remote computer and this
unit.
Install the FAM driver on the remote computer
(see the next item).
Set i.LINK(FAM) on the POWER SAVE page
of the OPERATION menu to ENABL (see
page 181).
To install the FAM driver
Insert the supplied CD-ROM (XDCAM
Application Software) into the CD-ROM drive of
your computer, and execute the FAM Driver
>Mac >dmg file of the FAM Driver, then follow
the installation instructions.
For details, refer to the ReadMe file contained on the
CD-ROM disc.
To check the FAM driver version
Connect this unit to your computer with an
i.LINK cable, and then, with a disc loaded, start
the system profiler utility of the application. The
version appears to the right of “prodisk_fs” when
you select “Advanced Functions” under
“Software”.
1 If there is a disc loaded in this unit, put
the unit into the following state.
Recording, playback, search and other
disc operations: Stopped
THUMBNAIL indicator: Off
Disc access by clip deletion, disc
formatting, or other operation:
Stopped
Picture Cache function and Interval Rec
function: Off
File Operations in File
Access Mode (for
Macintosh)
Making FAM connections