Filter
Top Products
Adjustments and Settings From Menus
181
Chapter 6 Menu Displays and Detailed Settings
a) Even when the MARKER item is set to OFF on
the MARKER page of the USER menu, the
ASSIGN 2 switch allows you to display or not to
display all markers.
b)The optional CBK-SC02 Analog Composite
Input Board is required for VBS signal input. The
optional CBK-HD01 HD/SD SDI Input Board is
required for SD-SDI/HD-SDI signal input.
c) Video momentarily becomes black and audio is
momentarily muted when the digital extender is
switched on and off.
d) This does not appear if nothing is assigned in the
Assign menu.
Note
For functions that are assigned to the ASSIGN 2
(slide-type) switch, you cannot change those
settings using other menus. The function assigned
to the ASSIGN 2 switch takes precedence over the
menu setting.
3 Select the desired function, and press
the MENU knob.
The function is assigned, and the
ASSIGNABLE SW page appears again.
Operation of the ASSIGN 1/2/3/4 switches when
UA01 to UA10 are assigned
When an on/off switchable function (or menu
item) is assigned to one of the ASSIGN 1/2/3/4
switches, each time the switch is pressed toggles
the function on or off.
When another type of menu item is assigned,
pressing the switch displays the item and its
setting value on the viewfinder screen.
You can then change the setting by pressing and
turning the MENU knob.
The viewfinder screen display disappears
approximately three seconds after the last
operation.
You can limit the function of some output
connectors to save power consumption.
(How to select an item in the menu screen: Turn
the MENU knob to move b to the desired item.)
1 Display the POWER SAVE page of the
OPERATION menu, and press the
MENU knob.
For details on menu operations, see “Basic
menu operations” on page 163.
2 Select the desired item, and press the
MENU knob.
You can set the following items on the
POWER SAVE page.
a) The unit must be powered off and on again to
enable changes to this setting.
3 Turn the MENU knob to select the
desired setting, and press the MENU
knob.
4 Repeat steps 2 and 3 until you have set
all of the desired items.
You can manually adjust the value of the white
balance by setting the color temperature.
(How to select an item in the menu screen: Turn
the MENU knob to move b to the desired item.)
1 Display the WHITE page of the PAINT
menu, and press the MENU knob.
For details on menu operations, see “Basic
menu operations” on page 163.
2 Select the desired item, and press the
MENU knob.
You can set the following items on the
WHITE page.
Setting power saving functions
Item Description
ETHERNET/
USB
Enables or disables the
network connector and USB
connector.
i.LINK(FAM)
a)
Enables or disables the
i.LINK connector (FAM
function).
REC AUDIO
OUT
Puts the AUDIO OUT
connectors in EE or SAVE
mode.
TEST OUT
SAVE
Switches the TEST OUT
connector power saving
function on and off.
ON: No signals are output if
a cable is not
connected.
OFF: Signals are always
output, regardless of
whether a cable is
connected.
Setting the color temperature
manually