Filter
Top Products
Setting the Status Display on the Viewfinder Screen and the LCD Monitor
172
Chapter 6 Menu Displays and Detailed Settings
a) The viewfinder display can be also turned on or
off by using the DISPLAY of the DISPLAY/
ASPECT switch on the viewfinder.
b) For detailed information on the display mode, see
“Change confirmation/adjustment progress
messages” (page 172).
VF DISP 2 page
a) When an Anton Bauer battery system or a BP-
GL65/GL95 battery pack is installed, the
remaining battery power is shown as a
percentage value (%) according to the setting of
this item.
INT: When one of the above batteries is
installed, the remaining power is shown as a
percentage value (%) when there is a change
in the value or when the power is low.
AUTO: The remaining power is shown as a
percentage value (%) when one of the above
batteries is installed. Otherwise the voltage
(VOLT) is displayed continuously.
VOLT: The voltage (VOLT) is displayed
continuously.
VF DISP 3 page
a) This makes it possible to display settings that
include reference settings, stored with STORE
ALL PRESET or other functions, as absolute
values.
3 Turn the MENU knob to select the
desired setting (ON, OFF, or value), and
press the MENU knob.
4 Repeat steps 2 and 3 until you have set
all of the desired items.
You can limit or suppress the messages that give
details of setting changes and adjustment
progress and results by setting a display mode.
The conditions under which messages are
displayed and their correspondence with the
display mode are as follows:
Y: Message is displayed.
N: Message is not displayed.
DISP DISC Remaining disc capacity
indicator
DISP IRIS Iris opening indicator
Item Description
DISP ZOOM Zoom position indicator
DISP COLOR
TEMP
Displays the color
temperature.
DISP BATT
REMAIN
a)
Displays the battery
voltage/remaining capacity
of an internal battery pack
or an external battery
connected to the DC IN
connector.
DISP DC IN Displayed when the power
is supplied from an external
battery connected to the
DC IN connector.
DISP 16:9/4:3
ID
Displays the video aspect
ratio (16:9 or 4:3). (When
the CBKZ-MD01 is
installed.)
DISP WRR RF
LVL
Displays the reception level
of the wireless microphone.
DISP REC
FORMAT
Displays the recording
format.
DISP CLIP
NO(PB)
Displays clip information.
DISP
TIMECODE
Displays the timecode.
Item Description
Item Description
LOW LIGHT Turns on and off the on-
screen warning that the
average level of the video has
dropped beneath a set level.
LOW LIGHT
LEVEL
Sets the LOW LIGHT
threshold value.
VF BATT
WAR NI NG
Specifies the remaining
battery capacity level that
starts the flashing warning in
the viewfinder.
ABSOLUTE
VA L U E
Turns on and off the mode
that displays numeric menu
settings as absolute values.
a)
Change confirmation/adjustment
progress messages
Message display
condition
Message Display
mode
setting
1 2 3
When the filter
selection has been
changed
FILTER: n (where
n = 1, 2, 3, 4)
NNY