ARRI 416 Film Camera User Manual


 
1010
10.4.3 Load/Store Menu
The IVS can store up to 5 sets of settings and recall them. The
default values are a 6th set of settings. Thus it is possible to
make all settings for e.g. indoor shooting and store them as
setting 1. Shooting continues with some exterior scenes and
the operator will make all settings for this and store them as
setting 2. When the work is continued indoors, it is very easy
to recall all the settings stored as setting 1 and get the same
image appearance as before.
MENU LOAD/STORE
-> - STORE SET 1
(CONFIRM BY
ENTER)
- LOAD SET 1
(NO UNDO)
- SET ALL
SETTINGS TO
DEFAULT
- EXIT
Video-Ait-Sytem
A set of settings consists of all set-ups in the IVS. Everything
which can be set electronically, will be stored and recalled.
All video adjustments such as manual gain control, white
balance, icker free, outputs with or without data and line
interpolation as well as all inserter setups, e.g. user text insertion
off or on, frame lines and so on are stored and recalled.
The adjustment of the white level of the inserted data, an
inverse display and a ne adjustment of the vertical position
is described in chapters 10.4.5 White Level, Inverse and
Fine Positioning.
Changes made to settings are immediately activated.
Check all settings on a correctly adjusted monitor.
Enter the Load/Store submenu from the main menu.
Store Settings
The set of settings, that are currently active, can be stored
as one out of ve settings.
Move the cursor > with the Ê and Ë keys to the line
– STORE SET. Pressing the Í key will switch from 1 to 2
all the way up to 5 and then back to 1, the Ì key will
step in the opposite direction.