Filter
Top Products
11
Mini-Monitor Output as clean video or video with data
The mini monitor output can be programmed to have either
clean video or video with data. Both mini monitor outputs are
in parallel, so there are either no data, or data on both outputs.
If the on-screen menu control is on (red LED next to the
Enter/Insert key Ñ is on), there will always be data in
this output. This is necessary because if the output is
switched to data off, no inserter information is visible and
therefore, it would be impossible to go back into the on-
screen menu to change the settings.
• Move the cursor > with the keys Ê and Ë to the line
– MINI MON DATA. Pressing the key Í or Ì will
switch the insertion of data in the mini monitor
between ON and OFF.
White Level
This line is used to change the brightness of all man readable
windows except the frame lines. Value 0 means dark grey,
value 3 corresponds to bright white characters.
• Move the cursor > with the keys Ê and Ë to the line
– TXT WHITE LEV.. By pressing the key Í the values
for the brightness of the characters will increment from
0 to 3, and after that back to 0. The key Ì will
decrement in the opposite direction.
Video-Ait-Sytem
MENU VIDEO/TEXT ADJUST
- FLICKERFREE ON
- LINE INTERP. ON
- SHARPNESS 2
- BNC OUT Y/C
- Y/C DATA ON
- GENLOCK OFF
-> - MINI MON DATA ON
- TXT WHITE LEV. 2
- TXT INVERS OFF
- TXT FINE POS 2
- EXIT
MENU VIDEO/TEXT ADJUST
- FLICKERFREE ON
- LINE INTERP. ON
- SHARPNESS 2
- BNC OUT VBS
Y/C DATA
- GENLOCK OFF
- MINI MON DATA ON
-> - TXT WHITE LEV. 2
- TXT INVERS OFF
- TXT FINE POS 2
- EXIT