Filter
Top Products
11
• Slide the Sled into the dovetail-guide of the Base Plate
until the spring-loaded stop pin aphoto snaps back
audibly. The Sled‘s position can then be xed with the
clamping lever.
• Fit the camera onto the short dovetail-guide on the
Sled. Slide it forward until the spring-loaded catch
aphoto locks it in place.
• Tighten the clamping lever of the Accessory Carrier
aphoto.
• Slide the support rods into the guides and clamp.
• Equip the camera with the required accessories to
determine the centre of gravity. Loosen the sled
clamping lever, and by sliding the camera on the base
plate nd the optimum balance position. Then retighten
the clamping lever.
The accessory carrier has the same dovetail as
the bridge plate so it can be mounted to the
base plate.
If the Lightweight Support is used and
accessories are mounted to the Lightweight
Support rods these accesories will collide with
the base plate. In this conguration the
accessory carrier can not be mounted to the
base plate.
cylindrical pins
Intallation