ARRI 416 Film Camera User Manual


 

Inching
The camera can be inched by pressing the “PHASE” button
while the camera is in Standby. If the “PHASE” button is only
pressed briey, the mirror shutter rotates a part revolution
to enable an unrestricted view of the lm gate (e.g. for
checking the gate). If the “PHASE” button is held pressed
longer, the camera will inch forward at approximately 1 fps.
During inching the upper line of the display indicates the
measured shutter angle, the lower line the measured
voltage of the power supply.
While inching, the camera speed is not exactly
controlled. As this can cause faulty exposures,
do not lm while inching.
9.3 Displaying and Setting
Operational Parameters
The currently set operational parameters on the ARRIFLEX 416
are displayed on the camera display aphoto in various
modes. The desired mode is selected via the “MODE” button.
In each mode the corresponding operational parameters
can be set using the “SEL” and “SET” buttons aphoto.
Note: The Mode numbers are shown in the display
between the upper and the lower line. Mode 1
is also indicated aphoto in the display by a
black horizontal bar.
To prevent an unintentional alteration of the operational
parameters the buttons “SEL”, “SET”, and “PHASE” can be
locked using the “LOCK” button. If a button is pressed when
the display is locked, the display will show the “OFF” sign.
If the display is locked, this is indicated by the “LOCK”
symbol in the display.
Note: Locking the “PHASE” button has no inuence
on the inching function.
Locking the “SEL” and “SET” buttons has no
inuence on accessories such as the RCU-1.
CameraOperation