Filter
Top Products
416 Lightweight Support LWS-5
The 416 Lightweight Support LWS-5 is a sturdy, three point
bracket for mounting 15 mm lightweight support rods. The
LWS-5 is tted with an Accessory Rosette to replace the
camera‘s rosette which is covered when the LWS-5 is
tted aphoto.
• Fit the LWS-5 to the camera by rst engaging the two
guide pins of the upper 3/8-16 screw on the camera
right side aphoto. This will position the LWS-5 so
that the 3/8-16 screw on the front of the bracket lines
up with the threaded hole In the camera. Engage this
screw by a few threads but leave it loose aphoto.
• Tighten the two screws on the camera right side – the
lower one is accessed through a hole in the Accessory
Rosette teeth aphoto.
• Tighten the front screw.
• Slide the support rods into the guides and clamp.
Note: Due to the camera‘s small dimensions and because
the distance from the lens to the support rods is
xed, the rod clamps of the LWS-5 project below
the camera base. To mount the camera with the
LWS-5 tted on a support system such as the Steadi-
cam, it is necessary to t the 416 Riser. This
presents a at base, clear of the support rods,
with selection of threaded holes.
LWS-5
Intallation
upper screw
rosette
clamp
front screw
clamp
lower screw