ARRI 416 Film Camera User Manual


 

Frame Rates
The ARRIFLEX 416 offers the possibility to set and store
two frame rates. It is possible to select and store:
a standard frame rate (23.976, 24, 25, 29.97 and 30 fps)
and a freely programmed frame rate between 1 and
75 fps in increments of 0.001 fps.
The frame rate is activated via the “NORM“ and “PS/CCU”
buttons aphoto on the left of the camera. The “NORM”
setting corresponds to the standard frame rate, the “PS/CCU”
position to the freely programmed frame rate.
Selecting a Standard Frame Rate (Mode 1)
Standby Operation
The camera must be in Mode 1 and the camera must
be set to “NORM”.
Press the “SEL” button repeatedly until the desired
frame rate is selected. Within 3 seconds, conrm this
choice by pressing the “SET” button, otherwise the
initial setting is retained.
Note: If the total exposed lm counter is displayed in
Mode 1, pressing “SEL“ rst steps through the
digits of the total exposed lm counter before
the choice of frame rate is offered.
CameraOperation
RUN button
black bar to indicate Mode 1
PHASE button
MODE button SEL / SET buttons
NORM button
PS/CCU button
LOCK button