ARRI 416 Film Camera User Manual


 

Display Beep on start Beep on stop
LS _ _ off off
LS – _ on off
LS _ – off on
LS – – on on
Switching the Beeper On and Off (Mode 6)
Standby Operation
Press the “MODE“ button until the display shows Mode 6.
By pressing the “SEL” button once, activate the display
for setting the Beeper.
Within three seconds, press the “SET” button to select
one of the four settings.
Pressing the “MODE” button conrms the selection.
Setting the Volume of the Warning Signal
(Mode 6)
Press the “MODE“ button until the display shows Mode 6.
Press the “SEL” button two times to activate the display
for setting the Beeper volume.
Select the desired volume with the “SET” button.
0…off
3…maximum volume
CameraOperation