ARRI 416 Film Camera User Manual


 

Swing the footage counter roller arm aphoto away
from the feed side core holder until it locks in place.
Remove the lm from the lm can and black bag.
Remove the tape from the lm head. Ensure that the
tape is completely removed and secured out of the way.
Place the lm roll on the core holder so that it unwinds
in the direction shown aphoto. Press it down fully.
When placing the lm on the core holder, do
not push on the lm itself as it could become
conical. Push on the lm core instead.
Hold the lm roll still and turn the core holder until the
core holder key clicks into the key slot of the lm core.
Make sure the core holder cannot turn any further.
Release the footage counter roller arm gently so the roller
rests on the outer surface of the lm roll. The sides of
the roller should overlap the lm roll edges aphoto.
Push approximately 15 cm (6“) of lm into the slit at
the top of the angled transfer roller. Then thread the
lm around the guide roller.
Hold the lm still where it enters the transfer roller and
gently back-tension the lm roll to remove any slack.
Replace and lock the feed side magazine door, being
careful not to trap any lm in the process.
Check if the door is properly closed before removing
the magazine from the changing tent or dark room.
footage counter roller arm
lm core
lm roll
Magazine
transfer roller
guide roller