ARRI 416 Film Camera User Manual


 

Running the Camera
If the operation control indicator glows red while in Standby,
the camera is not ready and will not run (see “Overview
of Display Symbols”).
Briey press the “RUN” button. While the camera is
running up to speed, the operation control indicator
aphoto glows red. Once the set frame rate has been
reached, the operation control indicator turns green.
Note: If the “PHASE” button has not been pushed after
power on or after a new magazine has been
attached, the rst time “RUN” is pressed the camera
performs a 2 second loop check before running.
Stopping the Camera
Press the “RUN” button again aphoto briey. While
the camera is slowing down the operation control
indicator glows red. The mirror shutter automatically stops
in a position that enables unrestricted viewing through
the viewnder. On reaching this position, the operation
control indicator ashes green before going out.
CameraOperation
RUN button
RUN button
phase button
SEL/SET
buttons
operational control indicator
black bar
to indicate
Mode 1