Filter
Top Products
Shifting phase
After the camera has run up, the frame rate can be
temporarily increased by 0.2 fps while the button the
“PHASE” is held pressed aphoto. This is normally used
when synchronizing to an interlaced video signal – look
through the viewnder and hold the “PHASE“ button
pressed until the bar in the video picture is no longer visible
on the monitor. Always conrm results with a lm test.
Displaying Power Supply Voltage (Mode 3)
CameraOperation
RUN button
PHASE button
• Change from Mode 1 to Mode 3 by pressing the
“MODE” button twice. The power supply voltage is
shown in the lower line of the display.
Note: If the camera has an OBB-2 attached, the
options of battery capacity (in percent) or
remaining magazines can be displayed instead
of voltage.