ARRI 416 Film Camera User Manual


 
11
26.2V RUN FWD 24.000/24.000fps 180.0 F 120FT
lm camera voltage in
standby (STBY), run (RUN) or not ready (NRDY)
actual lm camera speed in fps
selected lm camra speed in fps
shutter mirror angle (only after camera was running)
counter is take (T) or footage (F) counter
lm counter
counter is meter (M), foot (FT), or seconds (s)
Video-Ait-Sytem
The lm counter gets its data from the lm camera. So the
data on the IVS is identical to the data in the lm camera.
If the lm counter is in the take mode, the data in meters,
feet or seconds of the last take is displayed. In the footage
mode, the total length of the lm run through the camera
is displayed, either in meters or feet.
During on-screen programming inserted data is
not fully updated (e. g. Frame Counter Information).
To update the information, leave the on-screen
display menu by pressing the Enter/Insert key
Ñ for more than three seconds.
When the lm camera is rst switched on, no
mirror shutter angle is displayed. Data only
appears after a few revolutions of the mirror shutter.
The System line, LDS line and Status line live together as a
package. If all lines are on, the upper line will always be
system, the middle line LDS and the lower line status.
Positioning always affects all lines together.
Like all man readable information, the data is inserted as
a window on the monitor image. Each window can be
switched on and off independently. Background and position
can be altered without affecting the settings of other windows.
The adjustment of the white level of the inserted data, an
inverse display and a ne adjustment of the vertical position
is described in chapters 10.4.5 White Level, Inverse and
Fine Positioning.
Enter the System/LDS/Status submenu from the main menu.
Changes made to settings are immediately activated.
Check all settings on a correctly adjusted monitor.