Filter
Top Products
6.2 Checking the Loop Size
• Turn the magazine so the throat is pointing upwards
with the feed side facing you.
• Push the loop to the left so all the slack is below the
pressure plate.
• The end of the loop must fall within the white line
marked in the lower throat chamber aphoto.
• If the loop length is not correct push down the button in
the midlle of the lower sprocket and turn the sprockets
against each other to alter the loop length. Make sure
the sprocket engages properly again after changing
the loop size. Check loop length again.
white line
lay-on roller arm
Magazine
sprocket adjusting button