ARRI 416 Film Camera User Manual


 

Hold the lm between thumb and middle nger of your
left hand, while using your index nger to push the lm
head into the lower magazine throat slot. The angle at
which the lm enters is not as critical as it is on the old
SR magazines.
Keep pushing the lm in with your index nger until
you see the sprockets rotate aphoto. Now take hold
of the lm core again and rotate it counter-clockwise.
This will pull the lm from the throat into the take-up
chamber.
Thread the lm around the rear guide roller following
the path indicated in the magazine.
Insert the lm head into the lm core and manually
wind the core holder two or three turns until the lm
winds tightly onto the core.
Unlatch the lay-on roller arm.
Close and lock the take-up side door.
If using timecode, set the sensitivity switch according to
the table In the Timecode section of this manual. The
switch is located at the top left corner of the feed side
door aphoto.
lm core
lower
magazine
throat
lm core slit lay-on roller arm
Timecode sensitivity switch
Magazine