Filter
Top Products
5-14
Restore the Factory Default Settings
Note
● Never power off the camera while the restore operation is in progress. If turning off
before completion, the camera may not work properly.
● Once you click “OK”, the process cannot be cancelled.
Restore the Factory Default Settings from the Maintenance Menu Using a Web Browser
Since VB-C60 supports various functions, it is recommended to take a note of each setting value.
If you need to redo settings from the beginning because you have forgotten them or for some
other reasons, restore the factory default settings.
* For information on the factory default settings, refer to P.5-16.
1. Start a Web browser and access the camera’s
setting page
The camera’s IP address, user name and
administration password are required to display the
setting page (➞ P. 1-8).
2. Click “Maintenance” on the setting page
The Maintenance page is displayed.
3. Click “Restore” in the “Restore Settings”
submenu
A message of whether to restore the factory default
settings is displayed for confirmation. Click “OK” to
restore the factory default settings.
4. All settings in the camera will be returned to the factory default settings
All settings will be restored to the factory default settings, except camera’s administrator
password, IP address, subnet mask, default gateway address, date and time, time zone, LAN
interface, maximum transmission unit, and IPv6 use. The camera will be automatically rebooted
after the restoring process.