Filter
Top Products
5-15
Appendix
Restore the Factory Default Settings
Note
If you use the reset switch to initialize VB-C60, all the settings including the network-
related settings (IP address, subnet mask, and default gateway address) will be
initialized. Therefore, you cannot use the camera from the PC connected to the camera
via the network after reset. Set the IP address for your environment using “VB Initial
Setting Tool v4.0” installed in the PC when initializing the camera (➞ d Start Guide
P.2-9).
If you have forgotten the IP address or Administrator password of VB-C60, you cannot control the
camera via the network. In this case, press the reset switch on the rear of the camera.
1. Power off the camera
For information on how to power on/off the camera, refer to “Turning ON / OFF” (➞ d Start
Guide P.2-7).
2. Switch on the camera with holding down the reset switch, then keep holding
the reset switch for at least 5 seconds
The reset switch is recessed from the rear panel. Use a thin tipped object to press the reset
switch.
All settings will be initialized.
Initialize the Camera using the Reset Switch
Reset Switch