Filter
Top Products
1-16
▼Day/Night
1 Mode
Select the switching mode from “Manual” and “Auto”. When specifying “Auto”, you can set
“Switching Brightness” and “Response” according to the environment where the camera is
installed or the switching condition.
* If you are using an infrared lamp, you cannot use “Auto”.
2 Switching Brightness
Select the brightness level to switch day mode and night mode from “Darker”, “Slightly Darker”,
“Standard”, “Slightly Brighter” and “Brighter”. When you prefer to shoot color video as much
as possible, select “Darker”. When you prefer to reduce noise even in black and white video,
select “Brighter”.
3 Response (sec.)
Select the time, at which day mode and night mode switches, from “5”, “10”, “20”, “30” and
“60”. The day and night mode are switched when the brightness set in the above 2, maintains
for a set period of time. It is recommended to specify “30” or “60” for situations, where the
brightness frequently changes, for example, light sources pass in front of the camera. Or,
specify “5” or “10” for situations, where there are few changes in brightness.
Set the Camera Control and External Device Names (Camera)
2 Image Stabilizer
Select whether or not to activate Image Stabilizer from “Disable”, “On1” and “On2”. Image
Stabilizer effectively works to compensate for image blur caused by camera shake. If “On1” is
not strong enough to correct the image blur, try “On2”. While Image Stabilizer is being activated
with “On1” or “On2”, the viewing angle may be narrower and the image quality may be degraded,
comparing with when Image stabilizer is disabled. This is because of the stabilization process,
not camera failure.
Approx. 80,000 pixels
Blur Level Ratio of viewing angle No. of effective pixels
Disable
_
100% Approx. 310,000 pixels
On1 Small 83% Approx. 210,000 pixels
On2 Large 50%
Note
● It is recommended to set the image capture size to “320 x 240” or smaller, while
specifying “On2”.
● IS does not work to correct vibration of a subject itself.
● Image Stabilizer cannot correct image blur caused by instantaneous shake or large
vibration that exceeds a certain level.
● Refer to P.3-20, for note on viewer use while Image Stabilizer is being activated.
1
2
3