Filter
Top Products
3. Remove and reinsert all of the printheads. See Remove a printhead on page 62 and Insert a printhead
on page 65. This starts the printhead alignment process.
NOTE: Make sure the printer window is closed during printhead alignment.
4. The process takes about 10 minutes. Wait until the front panel shows that the process is complete
before using the printer.
NOTE: A calibration image is printed during the printhead alignment process. The front panel shows if
there were any errors in the process.
Image Quality Maintenance menu procedure
1. Load the paper you want to use. Photo paper is recommended for the best results. Plain; bond; and thin,
coated papers are acceptable, but provide marginal results.
WARNING! Colored papers, glossy canvas, and transparent materials such as translucent bond, clear
film, tracing paper, and vellum are not suitable for aligning the printheads. However, if you must
perform printhead alignment with a material that is not supported, make sure you use a material with
the same thickness as the material you are going to use for printing.
2.
Go to the front panel and select the
icon, then select Align printheads. The printer checks that a
sufficient amount of paper exists to perform printhead alignment.
176 Chapter 15 Troubleshoot ink-system issues ENWW