Filter
Top Products
NOTE: During the initial printer setup, printhead alignment and color calibration are performed
automatically after the roll is loaded into the printer.
Unload a roll from the printer
NOTE: If you used the take-up reel during printing, unload the printed roll from the take-up reel before
attempting to remove the roll from the printer. See
Unload a roll from the take-up reel on page 40.
1.
At the printer's front panel, select the
icon, then Paper unload > Unload roll.
2. The paper is unloaded from the printer.
3. Release the spindle lock.
4. Remove the roll from the printer, pulling out the right end on the right side of the printer first. Do not
insert your fingers into the spindle supports during the removal process.
Use the take-up reel
CAUTION: Make sure the printer is turned off when installing the take-up reel motor on the printer.
The take-up reel is operated from the front panel.
Follow these guidelines when taping rolls to the take-up reel spindle core:
●
Make sure that the paper is straight when it is attached to the spindle core. Otherwise it skews as it
winds onto the core.
●
The spindle core on the take-up reel must be the same width as the paper that you are using.
●
Check that neither side of the spindle core has end caps, and make sure the spindle core is pushed
firmly into both spindle guides.
NOTE: If you want to load the take-up reel during printing, familiarize yourself with the procedural steps.
Loading the take-up reel during printing requires you to complete the procedure while the printer is feeding
and printing paper. Loading the take-up reel during printing saves approximately 1 m (3 ft) of paper.
Load a roll onto the take-up reel
1.
On the printer's front panel, select the
icon, and then select Paper load > Load take-up reel.
ENWW Unload a roll from the printer 35