Filter
Top Products
15. The following image shows how the printer looks when it is operating. As paper is fed from the printer,
it drops down in a loop and then up into the take-up reel spindle.
NOTE: While the take-up reel is operating, make sure that the take-up reel sensors are not blocked.
NOTE: The automatic paper-cutter is disabled when the take-up reel is in use.
NOTE: If you want to move the printer, first remove the take-up reel sensor and cable housing unit from the
foot of the printer stand. Place the sensor and cable housing unit on the printer stand crossbar and use the
blue plastic screw to affix the housing unit to the leg of the stand, as shown, while the printer is being moved.
When reinstalling the housing unit, make sure that the wheel on the foot of the printer stand is pointing
forward.
Unload a roll from the take-up reel
1.
On the printer's front panel, select the
icon, and then select Paper unload > Unload take-up reel.
The printer advances the paper to allow for cutting.
2. Lift the loading table to its upright position.
40 Chapter 4 Handle the paper ENWW