Filter
Top Products
108
Preparation: Power Supply
A battery pack or an external DC power supply can be used as AJ-HPX3100’s power supply.
Battery packs from the following manufacturers can be used:
• Anton/Bauer
• IDX
The type of the battery can be checked or changed through
the viewfinder or menu screen on the monitor.
z Pull the MARKER SEL, MODE CHK / MENU CANCEL
switch on the camera-recorder to display at the upper right
of the viewfinder screen the currently set battery type.
z Through the BATTERY SELECT menu option, you can
check and change the battery type. The menu item
BATTERY SELECT is found in the <BATTERY/P2CARD>
screen on the MAIN OPERATION page.
Notes
z Other batteries may be used by changing the menu setting
(TYPE A item, TYPE B item, TYPE C item), but system
compatibility is not guaranteed. These menu items are found
in the <BATTERY SETTING> screen on the MAIN OPERATION
page.
z Charge the battery pack with the battery charger before
using it. (Please refer to the battery charger’s instruction
manual for information about charging.)
z When using a light (Ultralight 2), a battery of 90 Wh or higher
is recommended.
z When using studio systems (AG-BS300P/E, AG-CA300G) for
lighting, affix an AG-CA300G to the battery plate, mount the
battery, and supply the light with power from the battery
plate. If the power for lighting is provided from the light
socket on this unit, the excessive current draw from the AG-
BS300P/E and AG-CA300G during lighting may result in this
unit not starting.
Using a Battery Pack
#
< BATTERY/P2CARD >
BATTERY SELECT :DIONIC90
EXT DC IN SELECT :AC-ADPT
BATT NEAR END ALARM :OFF
BATT NEAR END CANCEL:ON
BATT END ALARM :ON
BATT REMAIN FULL :70%
CARD NEAR END ALARM :ON
CARD NEAR END TIME :2min
CARD END ALARM :ON
CARD REMAIN/
:3min/
Preparation
Power Supply
AJ-HPX3100G(VQT3A79)_E.book 108 ページ ２０１０年９月１７日 金曜日 午後９時２１分