Filter
Top Products
191
Menu: Menu Description Tables
Menu
MIC/AUDIO (3/3)
Items/
Data Saved
Adjustable
Range
Remarks
FRONT MIC
POWER
ON
OFF
Select the phantom power supply for the
front microphone.
–CUF–
REAR MIC
POWER
ON
OFF
Select the phantom power supply for the
rear microphone.
When OFF is selected, no phantom power
is supplied even if the REAR AUDIO CH1
or CH2 switch is set to +48 V.
–CUF–
MONITOR
SELECT
STEREO
MIX
When the MONITOR switch is set to ST
(stereo), select the signal format for the
monitor output.
–CUF–
FRONT MIC
LEVEL
–40dB
–50dB
Select the front microphone input level.
–CUF–
REAR MIC
CH1/3 LVL
–50dB
–60dB
Select the rear microphone input level.
–CUF–
REAR MIC
CH2/4 LVL
–50dB
–60dB
Select the rear microphone input level.
–CUF–
REAR LINE IN
LVL
+4dB
0dB
–3dB
Select the rear line input level.
–CUF–
AUDIO OUT
LVL
+4dB
0dB
–3dB
Select the audio output level.
–CUF–
HEADROOM 18dB
20dB
Set the headroom (standard level).
–CUF–
WIRELESS
WARN
ON
OFF
Select whether or not to enable the alarm
to trigger for poor wireless receiver
reception.
–CUF–
WIRELESS
TYPE
SINGLE
DUAL
Select the type of wireless receiver.
SINGLE:
Select a single channel wireless
receiver.
DUAL: Select a 2-channel wireless
receiver.
–CUF–
TC/UB
Items/
Data Saved
Adjustable
Range
Remarks
TC MODE DF
NDF
Set the time code mode.
DF: Drop frame.
NDF:Non drop frame.
Note
When the camera-recorder operates at
50 Hz or in 24P or 24PA mode, the non-
drop frame is always used.
–CUF–
UB MODE USER
TIME
DATE
EXT
TCG
FRM RATE
REGEN
Select the user bits mode.
USER: Select UB value set in the LCD
section.
TIME: Select local time (hours, minutes,
seconds).
DATE: Select local date and time (2 last
digits of year, month, date, time).
EXT: The user bits input to the TC IN
connector are recorded.
TCG: TCG value enters UB.
FRM RATE:
Select the shooting information (e.g.
frame rate) for the camera. For more
information, see [Frame rate
information recorded in user bits] (page
64).
When clips recorded in Native mode
are played back, the frame rate
information recorded in VITC users bits
is output.
REGEN
: Read out value stored in the card
and record value continuously.
–CUF–
AJ-HPX3100G(VQT3A79)_E.book 191 ページ ２０１０年９月１７日 金曜日 午後９時２１分